![]() ![]() There are several third party fan control programs which may work with your motherboard e.g. There's also a AI app for controlling fans as described on page 29 of the documentation Which contains a fan control applet described on page 25 of the documentation. You can also download the MSI Center software for your motherboard And the radiator could be connected to any of the sys fan 3 or 4 or 5 connectors on the bottom of the motherboard. The top fan would be connected to sys fan 6 which is on the front edge of the motherboard near the top. The rear fan would be connected to sys fan 1 which is located nearest the back of the case. The sys temperature is usually read from a sensor embedded in the motherboard. MSI MEGA 180 Motherboard Chipset: NVIDIA nForce2 (Crush I8G) + MCP2T Memory slots: 2x DDR 333 up. There are six case fan options plus the cpu and pump options. The remote that controls the MEGA PCs' hi-fi functions. (I couldn't upload the image it said 'Something went wrong.')Ĭlick to expand.Well for starters, you could look at page 29 of the manualĪnd see where all of the connectors are. I'll take any suggestions if people think a certain software is better for this than going through the BIOS - it would be a lot easier to adjust. I've attached an image which hopefully shows the layout, but essentially I have two OUT fans at top and rear, radiator/IN fans on the front, GPU roughly in the middle with CPU/memory above and PSU at the bottom. MOSFET Baseplate Baseplate on the back to keep MOSFET in lower temparature, ensuring better heat dissipation effect. Pump Fan Support Control watercooling pump speeds for best flow and noise control. So, what I want to know is which would be the best source to use to control the fans spinning up faster in order to best cool my GRAPHICS CARD. With double ball bearings fan to keeps M.2 SSDs safe while preventing throttling, making them run faster. I'm not 100% sure on the others (or where in the case they are) but one is SYS, which I understand to be the general temperature inside the case (although where this temp is read from I'm not sure). There are 5 options from memory, of which CPU is the default (it was a shame not to see GPU as an option, coming from iCUE again). I played around a little with the curves to get them how I want them, but I'm a little confused on the SOURCE. Kinda annoying not to be able to do it on the fly but w/e that was on me.Īnyways. I've recently got my new PC and I've gone from controlling the fans on my old one through iCUE (super easy) to now doing it through the BIOS on this system.
0 Comments
Leave a Reply. |